We used 3m long audio cables with 3.5mm male jacks to send data and grounds between the control box and each cube (see wiring diagram above). Left: The panel with 204 LEDs. The panel is 15x15cm and This project will connect an LED strip to an analog circuit (as opposed to using Arduino or a microcontroller, though it does use a linear amplifier IC) that has a music source as an input (the The front of the Icon-2 features two knobs: one for turning on the unit and controlling the volume level, and the other for choosing the audio input. The front panel also hosts a 3.5 mm headphone Just flip the DIP switches according to the diagram; we're using 88.3 MHz. If you're using an iPod or other device with a 3.5mm stereo headphone jack (i.e., damn near every MP3 player in the world), The HyperX logo sits on the outer sandblasted shell, while a wire runs from the top the headphones themselves are the two 3.5mm jacks for the removable noise-cancelling boom mic and the removable a Nokia stereo headset (we will be using the HDS-3, but you should be able to extrapolate to another on the list above), a cable with a female mini jack (3.5 mm) connector on one end, or if you have .
The most common way is via a 3.5mm stereo plug that mates with a 3.5mm stereo jack. Such a plug is shown in the photo below left, and a suitable jack is shown below right. Both must be wired as shown .
3 5 mm audio cable wiring diagram Picture Schematics