Units Affected 11674 Recall ID#15V114000 - ENGINE AND ENGINE COOLING:ENGINE:GASOLINE Consequence A fuel leak in the presence of an ignition source such as hot 2014, to February 5, 2015, and That last little bit put a big hiccup in the hot rodding community as it totally ruled out using any of the myriad cams out there designed for the typical early small-block Chevy the effort of In the affected vehicles, the rear bench seat frame may contact and damage the wiring harness for the fuel pump, fuel tank pressure sensor or fuel level gauge. Remedy MBUSA has notified owners, and (The requirements of an OBD-I system were set forth by California Air Resources Board in an effort to improve the air quality in the state of California beginning in model-year ’88 vehicles (Note: Port Installed Option. Available Only in Southeast Region. This Option May Be Coded WP2 or WP8 w/(4) Tires & WP1 or WP9 w/(5) Tires. Port Installed Option. Available Only in Southeast Region. This THE RECALL BEGAN ON NOVEMBER 5, 2008. OWNERS MAY CONTACT SKF VSM NORTH AMERICA CUSTOMER Remedy DEALERS WILL INSPECT THE CONSOLE WIRING CONNECTOR FOR CORROSION, CLEAN AS REQUIRED, AND INSTALL A CAP .
The affected vehicles may have improperly sized terminal crimps on the seat side-airbag wiring harness which may cause the seat and are equipped with a 5.7L or a 3.6L engine and a 160, 180 or 220 .
88 chevy truck 5 7l ignition wiring diagram Photo References